Hello, I've got a profile that, when verified, is substantially better than without using it (as one would hope!!!). But a few of the colors are red and not green in the verification.

It may be that these colors were not measured well (perhaps the extra delay time was insufficient for example, since I'm generating the patterns over the network).

Regardless, specifically how do I go about updating those problematic colors?

Thanks for any and all help!

-Verxion

Open the profile, and open the Manual Measure page.
Double click on the point in the profile to select it, which will also set the patch colour to that point's colour,
Press Measure.
(The User Guides do explain this too.)

Oh, you can also change the probe settings, to increase Integration time, etc. too.

Steve

Thank you - I wasn't double clicking!

-Verxion